Shop Refurbishment Photos.

Here we are before the job started removing posters etc. to clear the shop.

View from the back of the shop






Pictures below are almost a panoramic shot showing the new steel bases with fresh concrete or ready for the concrete to be cast.

 

Here we are in happy chaos. We are constantly moving the machinery around.  This view through to the back of the shop shows the paypoint corner.
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor. (View to dryers)
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor. (View to washers.)
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor.
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor.
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor.
The best way to run new wiring, Hot and Cold water, drains and the paypoint wires is through a set of ducts across the shop floor.
Machines on the plinth at last.
New large washers. (16lb.) The in-fill to the LHS of the machines (now only four where there used to be five) gives space for an extra dryer.
New Mammoth and Jumbo size washers. (40lb and 30lb)

 

Our new paypoint up and running.



The job has yet to be completed. We had a few delays deciding on a new/second hand dryer, and couldn't commit to a new floor until the dryer was put in place.